## hpr3768 :: Jeep Ignition Repair

 I should have started by removing these two screws

Click the thumbnail to see the full-sized image
But I actually started with two of these screws, removed the knee board, then removed the third screw

Click the thumbnail to see the full-sized image
I removed the ignition assembly by removing these three screws. There is a large bump on the bottom, this is where the spring that lifts the ignition locking mechanism goes

Click the thumbnail to see the full-sized image

Click the thumbnail to see the full-sized image
The piece of ignition that had broken

Click the thumbnail to see the full-sized image
Replacement part. The marked part is very delicate and will snap easily

Click the thumbnail to see the full-sized image
